2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
•
Serial ATA3 Connectors
(SATA3_1: see p.11, No. 13)
SATA3_5
(SATA3_2: see p.11, No. 14)
(SATA3_3: see p.11, No. 12)
(SATA3_4: see p.11, No. 15)
(SATA3_5: see p.11, No. 11)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB10_11)
(see p.11 No. 27)
(9-pin USB8_9)
(see p.11 No. 26)
(9-pin USB6_7)
(see p.11 No. 25)
Infrared Module Header
(5-pin IR1)
(see p.11 No. 28)
These five Serial ATA3
(SATA3) connectors support
SATA3_3
SATA3_1
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
SATA3_4
SATA3_2
6.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
Besides eight default USB 2.0
USB_PWR
P-11
P+11
ports on the I/O panel, there are
GND
DUMMY
three USB 2.0 headers on this
1
motherboard. Each USB 2.0
GND
P+10
header can support two USB
P-10
USB_PWR
2.0 ports.
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
USB_PWR
P-7
P+7
GND
DUMMY
1
GND
P+6
P-6
USB_PWR
This header supports an
IRTX
+5V
DUMMY
optional wireless transmitting
and receiving infrared module.
1
GND
IRRX
2 3
2 3
2 3
2 3
2 3