Storage Configuration - ASROCK 790GX PRO User Manual

3.4.4

3.4.4 Storage Configuration

3.4.4 3.4.4 3.4.4 Storage Configuration Storage Configuration Storage Configuration Storage Configuration
BIOS SETUP UTILITY
Advanced
Storage Configuration
[Enabled]
Onboard SATA Controller
SATA Operation Mode [IDE]
IDE1 Master [Not Detected]
IDE1 Slave [Not Detected]
SATAII_1 [Not Detected]
SATAII_2 [Not Detected]
SATAII_3 [Not Detected]
SATAII_4 [Not Detected]
[Not Detected]
SATAII_5
eSATAII_1 [Not Detected]
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Onboard SATA Controller
Use this item to enable or disable the "Onboard SATA Controller" feature.
SATA Operation Mode
Use this item to adjust SATA Operation Mode. The default value of this
option is [IDE]. Configuration options: [AHCI], [RAID] and [IDE].
IDE Device Configuration
You may set the IDE configuration for the device that you specify. We will
use the "IDE1 Master" as the example in the following instruction, which can
be applied to the configurations of "IDE1 Slave" as well.
BIOS SETUP UTILITY
Advanced
Primary IDE Master
Device :Hard Disk
Vendor :MAXTOR 6L080J4
Size :80.0 GB
LBA Mode :Supported
Block Mode :16Sectors
PIO Mode :4
Async DMA :MultiWord DMA-2
Ultra DMA :Ultra DMA-6
S.M.A.R.T. :Supported
Type [Auto]
[Auto]
LBA/Large Mode
[Auto]
Block (Multi-Sector Transfer)
[Auto]
PIO Mode
[Auto]
DMA Mode
[Disabled]
S . M . A . R . T .
[Disabled]
32Bit Data Transfer
v02.54 (C) Copyright 1985-2003, American Megatrends, Inc.
Configure onboard
serial ATA
controller.
Select Screen Select Screen
Select Item
Select Item
+- +- Change Option Change Option
F1 F1 General Help General Help
F9 F9 Load Defaults Load Defaults
F10 F10 Save and Exit Save and Exit
ESC ESC Exit Exit
Select the type
of device connected
to the system.
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
5 3 5 3 5 3 5 3 5 3