Serial Ata (Sata) Hard Disks Installation; Hot Plug And Hot Swap Functions For Sata Hdds - ASROCK 775VM8 User Manual

2.9 Serial AT T T T T A (SA 2.9 Serial A 2.9 Serial A A (SA A (SAT T T T T A) Hard Disks Installation A (SA
2.9 Serial A 2.9 Serial A A (SA
This motherboard adopts VIA VT8237R southbridge chipset that supports Serial
ATA (SATA) hard disks and RAID functions. You may install SATA hard disks on
this motherboard for internal storage devices. This section will guide you to install
the SATA hard disks.
STEP 1: Install the SATA hard disks into the drive bays of your chassis.
STEP 2: Connect the SATA power cable to the SATA hard disk.
STEP 3: Connect one end of the SATA data cable to the motherboard's SATA
connector.
STEP 4: Connect the other end of the SATA data cable to the SATA hard disk.
2.10 Hot Plug and Hot Swap F 2.10 Hot Plug and Hot Swap F 2.10 Hot Plug and Hot Swap Functions for SA 2.10 Hot Plug and Hot Swap F 2.10 Hot Plug and Hot Swap F
775VM8 motherboard supports Hot Plug and Hot Swap functions for SATA
Devices.
NOTE
What is Hot Plug Function?
If the SATA HDDs are NOT set for RAID configuration, it is called "Hot
Plug" for the action to insert and remove the SATA HDDs while the system
is still power-on and in working condition.
However, please note that it cannot perform Hot Plug if the OS has been
installed into the SATA HDD.
What is Hot Swap Function?
If SATA HDDs are built as RAID1 then it is called "Hot Swap" for the action
to insert and remove the SATA HDDs while the system is still power-on
and in working condition.
A) Hard Disks Installation A) Hard Disks Installation A) Hard Disks Installation
A) Hard Disks Installation
unctions for SAT T T T T A HDDs unctions for SA unctions for SA unctions for SA
2 0 2 0
2 0 2 0 2 0
A HDDs A HDDs A HDDs A HDDs