ASROCK 775DUAL-915GV User Manual page 8

CAUTION!
1. About the setting of "Hyper Threading Technology", please check page 29.
2. This motherboard supports Dual Channel Memory Technology. Before you
implement Dual Channel Memory Technology, make sure to read the
installation guide of memory modules on page 18 for proper installation.
3. This motherboard doesn't support 128Mbit DRAM Cell (128MB/8 cells;
256MB/16 cells).
4. Although this motherboard offers stepless control, it is not recommended
to perform over-clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU.
5. While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
6. The AGI [ASRock Graphics Interface] slot is a special design that only
supports compatible AGP VGA cards. For the information of the
compatible AGP VGA cards, please refer to the "Supported AGP VGA
Card List for AGI Slot" on page 9 and page 10. For the proper
installation of AGP VGA card, please refer to the installation guide on
page 20.
7. For the information of the compatible PCI Express VGA cards, please
refer to the "Supported PCI Express VGA Card List for AGI Express Slot
(PCI Express x 4)" on page 11. For the proper installation of PCI Express
VGA card, please refer to the installation guide on page 20.
8. The Max. shared memory of onboard VGA is controlled by Intel VGA
driver. Installing different Intel VGA driver may vary its Max. shared
memory capacity.
9. For microphone input, this motherboard supports both stereo and mono
modes. For audio output, this motherboard supports 2-channel, 4-channel,
6-channel, and 8-channel modes. Please check the table on page 13 for
proper connection.
10. Power Management for USB 2.0 works fine under Microsoft
SP1 or SP2 / 2000 SP4.
® Windows
8 8 8 8 8
® XP