Create Disk Array - ASROCK 4CORE1333-FULLHD Installation Manual

Hide thumbs Also See for 4CORE1333-FULLHD:
Table of Contents

Advertisement

capacity and the other hard disk has 60GB, the maximum storage capacity for the 80GB-drive becomes
60GB, and the total storage capacity for this RAID 0 set is 120GB.
2.
You may use two new drives, or use an existing drive and a new drive to create a RAID 1 (mirroring) array
for data protection (the new drive must be of the same size or larger than the existing drive). If you use two
drives of different sizes, the smaller capacity hard disk will be the base storage size. For example, if one
hard disk has an 80GB storage capacity and the other hard disk has 60GB, the maximum storage capacity
for the RAID 1 set is 60GB.
3.
Please verify the status of your hard disks before you set up your new RAID array.
WARNING!!
Please backup your data first before you create RAID functions. In the process you create RAID, the system will ask if you
want to "Clear Disk Data" or not. It is recommended to select "Yes", and then your future data building will operate under a
clean environment.

1.3 Create Disk Array

Power on your system. If this is the first time you have booted with the disk drives installed, the ATI onboard BIOS will
display the following screen.
AHCI (tm) BIOS Version 2 . 5 . 1540 . 12
(c) 2004-2005 ATI Technology, Inc. All rights reserved.
No Array is defined...
Press <Ctrl-F> to enter FastBuild (tm) Utility...
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Alivexfire-esata2 r3.0Ati raidM3a uccAlivexfire-esata2

Table of Contents