Memobus Parameter Settings - Omron PROFIBUS DP GATEWAY Operation Manual

Memobus Communication
3-6-2

Memobus Parameter Settings

Parameter name
Device Address
Read Status Register
Read Frequency Register
Read Voltage Register
Write Command Register
Write Frequency Register
Write Voltage Register
Device Address
Read Register Address One
Read Register Address Two
Read Register Address Three
Write Register Address One
Write Register Address Two
Write Register Address Three
52
During configuration of the PROFIBUS Master unit the user must set a num-
ber of parameters, depending on the selected Communication block. De fig-
ure below shows the selection options for a Fixed Communication Block.
The parameter options are listed in the table below.
Range
(Hex)
00 ~ 1F Defines the Memobus address of the device to exchange the I/O
data of this module with.
0020 Address of the status register (Fixed).
0023 Address of the Actual Frequency register (Fixed).
0025 Address of the Actual Voltage register (Fixed).
0001 Address of the Command register (Fixed).
0002 Address of the Required Frequency register (Fixed).
0003 Address of the Required Voltage register (Fixed).
00 ~ 1F Defines the Memobus address of the device to exchange the I/O
data of this module with.
0000 ~ FFFF Address of first register to read from.
0000 ~ FFFF Address of second register to read from.
0000 ~ FFFF Address of third register to read from
0000 ~ FFFF Address of first register to write to.
0000 ~ FFFF Address of second register to write to.
0000 ~ FFFF Address of third register to write to.
Section 3-6
Description