Creating Function Block Data - Omron CX-PROCESS TOOL - INTRODUCTION GUIDE Introduction Manual

A node function block file labeled
will be added
under the Temperature Control
Project Folder
4
4

Creating Function Block Data

Creating Function Block Data
Next, actually create
simple function block data.
Click the plus sign (+) to the left of the
node function
block file, and then click the plus sign
on the LCU/LCB element folder
underneath it. The tree structure will be
opened.
The window shown on the right will
open when the 04. Block Diagram 1
Folder in the tree is double-clicked.
Paste the following three items into the
Function Block Diagram Window at the
right.
• Function block for analog input:
Isolated Ai 4-point Terminal (PTS51)
• Function block for PID: Basic PID
• Function block for analog output:
Isolated Ao 4-point Terminal (DA041)
.
3-4. A node function block file will be added
under the Temperature Control Folder.
4-1. Click the plus signs (+) to
display the tree structure.
4-2. Double-click the 04. Block
Diagram 1 Folder.
Seven folders will be
displayed under the Loop
Controller LCB03 V3.0
Folder: System, Field
Terminal, Sequence
Control, Block Diagram 1,
Block Diagram 2, and
Block Diagram 3.
Maximize
Function block diagrams
can be drawn at this point,
but to increase the area,
click the middle of the
three buttons. The window
will be maximized.
3
4
1-5