Terminal Covers made of phenol resin have five or six thin wall sections. These sections can be torn open for providing holes for lead cables at desired points.
20 Phillips screw of the cable to be used. (with plane washer and nut) Note: Each dimension has a tolerance of 0.4 mm unless otherwise specified. ( 0.8 mm for the AP-Z) Z/A/X/DZ F-190 Z/A/X/DZ Common Accessories...
Page 3
12.7 mm 12.7 mm MD max. 2.2 mm 3.3 mm 9.5 dia. 4.8 (stainless- FP max. 44.5 1.6 mm steel roller) Stainless steel 58.5R Note: Each dimension has a tolerance of 0.4 mm unless otherwise specified. Z/A/X/DZ F-191 Z/A/X/DZ Common Accessories...
Page 4
3. Incomplete screw section part (Note 2) head screw with a maximum of 1.5 mm Note: This Actuator (pin plunger) can be used with Standard Pin Plungers (Z-15G(-B), Z-15E(-B), X-10G(-B), DZ-10G-1A(-1B)) for the Z, X, and DZ models. Medium Panel Mount Plunger Model...
Page 5
20.4 mm 14.5 dia. MD max. 0.15 mm 0.2 mm 37 0.8 mm 20.7 23.9 Note: This actuator (roller plunger) can be used with standard pin plungers (Z- Spring washer (Note 2) Two, M4 25.4 20.7 15G(-B), Z-15E(-B), and DZ-10G- 11.9 screws 49.2...
Page 6
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. B106-E1-01 In the interest of product improvement, specifications are subject to change without notice. Z/A/X/DZ F-194...
This manual is also suitable for:
Dz - datasheet 2Ap-aAp-bAp1-aAp1-bAp-z...
Show all