Sennheiser WIRELESS DIGITAL Instruction Manual page 8

8
Connecting the mains unit
Insert the DC connector on the power supply output cable into
socket (refer to page 7) at the rear of the receiver.
Pass the cable through the cable grip
Connecting the amplifier/mixing console
Connect the amplifier/mixing console either
– to the XLR-3M socket
– to the 1/4" jack socket
Adjusting the AF output level
Use the AF output level control
appears at outputs
Switching the receiver on/off – Selecting a channel
Press the POWER button
Use the channel selector switch
Connecting additional A 1090 DIGITAL antennas
Additional digital antennas can be connected to the BNC sockets
if the range of the receiver's internal antennas is not sufficient. This may
happen if receivers are mounted into a rack or are installed between metal
constructions on a stage.
For connecting the antennas, use 50
Ready made up antenna cables from Sennheiser are available as accessories
(see chapter 11).
Depending on the location you can connect one or two digital antennas.
Attention:
Never connect conventional RF antennas to the BNC sockets as these
can damage the receiver!
.
or
.
to adjust the AF signal level that
and .
to switch the receiver on.
to select a channel.
coaxial cable with BNC connectors.
and