Using The Rs Headphone System; Switching On The Audio Source; Switching On The Headphones/Adjusting The Volume; Optimizing The Reception - Sennheiser RS 119 II Quick Manual

Place the headphones on the charging cradle of the trans-
mitter. The red LED lights up, indicating that the batteries
are being charged. The LED remains lit even when the re-
chargeable batteries are fully charged.

Using the RS headphone system

Switching on the audio source

4
Switch on the audio source. The transmitter automatically
switches on and off together with the audio source. The
ON/OFF LED lights up green.

Switching on the headphones/adjusting the volume

5
First, set the volume on the headphones to a low level.
Switch on the headphones and set the volume to the
desired level.
Switch off the headphones after use to avoid discharging
the batteries.

Optimizing the reception

6
Adjust the receiver channel with the
headphones.
However, if reception is subject to interference:
Change the transmission channel by setting the switch
at the bottom of the transmitter to another position and
re-adjust the receiver channel with the
the headphones. Some electronic devices (e.g. televisi-
ons) can cause interference to your wireless headphone
system. If this happens, increase the distance between
the transmitter and the interference source.
Specifications and
Frequently Asked Questions (FAQ's)
Visit our website at www.sennheiser.com.
TUNE control on the
TUNE control on
3