Advertisement
STD52_AU_Ed01.pdf 29/11/04 12:00 Page 3
Enter "Sub PIN:" 1590 (default) and press
The screen displays "HS No : Auto".
Press
to confirm.
Then, connect the repeater to the mains.
The repeater's light flashes rapidly.
Then, press and hold down the repeater's recording key (which is on
its back) for 5 to 10 seconds.
The repeater's light flashes slowly. Your repeater is now associated
with the base.
Unplug the repeater to install it in its permanent position, then plug it
in again.
2.2
SITING THE REPEATER
In order to optimise the radio quality of communications, fix the repeater
in a vertical position 2 metres from the floor, preferably away from obsta-
cles which may cause radio interference.
The minimum distance between 2 repeaters must be 10 metres.
!
If the repeater's light flashes rapidly, it is out of range of the
base; move it nearer to the base.
to confirm.
3
Advertisement
