Programming The Remote Control - THOMSON ROC 26 Manual

01-ROC 26 GB 3/03/04
Method A – Fast programming with 1-digit subcode
Before you start programming, you must find the subcode of the product to be
controlled (Television, VCR, satellite receiver or DVD player).
Refer to the list provided with these instructions, page I of the codes.
1. Turn on the product you want to control.
2. Hold down the S key ( 17) until the red indicator lamp ( 1) remains lit (the indicator
light remains on for a few seconds to give you the time to proceed with the following
steps. The indicator lamp flashes when this time is almost up, and then goes off).
3. Press the product key (2) that corresponds to the type of product you want to control:
TV: television set, VCR: video recorder.
4. While the indicator is lit, type in the subcode (example: 1 for THOMSON).
5. Point the remote towards the product and try to turn it off by pressing the
key B B (11).
6. If the product you want to control turns off, press OK (8) to save the subcode.
7. If the product doesn't turn off, press the B
off. Wait approximately one second between key presses to give the red indicator
lamp (1) enough time to go off and light up again. This will allow you to see whether
the product responds or not.
8. Immediately after the product to be controlled turns off, press OK (8) to save the
subcode.
Note:
If you want to assign another type of product than those mentioned on the remote control,
begin by entering the code that corresponds to the product you want to programme (a
3-digit code that you will find in the code booklet – see method B).
Example: if you want to control a satellite receiver with the VCR key, begin by entering
a satellite code (any satellite, for example: 603 for a Thomson satellite receiver) then
begin the procedure.
Checking the programming:
Your product should be ready to receive remote control commands. Check to see that
your remote functions correctly by performing the test described on page 4.
Method B – 3-digit codes programming
Before you start programming, you must find the code for the product to be controlled
(Television, VCR, satellite receiver, cable receiver or DVD player).
Refer to the list provided with these instructions, on page II of the codes.
1. Turn on the product you want to control.
2. Hold down the S key (17) until the red indicator lamp (1) remains lit (the indicator
light remains on for a few seconds to give you the time to proceed with the following
steps. The indicator lamp flashes when this time is almost up, and then goes off).
3. Press the product key (2) that corresponds to the type of product you want to control:
TV: television set, VCR: video recorder.
4. While the indicator is lit, enter the 3-digit code proposed for the product to be
controlled (example: 036 for THOMSON). The red indicator then goes off if the
code is correct or flashes, if the code is not on the list.
5. Point the remote control towards the product and try to turn it off by pressing the B
key (11).
6. If the product doesn't turn off, repeat step 2, using the next 3-digit code in the list.
Try to turn off the product by pressing B
one of the 3-digit codes works.
Checking the programming:
Your product should be ready to receive remote control commands. Check to see that
your remote functions correctly by performing the test described on page 4.
15:44 Page 2

3 - Programming the remote control

B key ( 11) repeatedly until the set switches
B key (11) once. Repeat this procedure until
2
+
+ +
B