Storing The Generator; Maintenance And Cleaning; Cleaning The Soleplate; Cleaning The Unit - TEFAL EASYCORD PRESSING Manual

NoticePressingEasycord_014004
Never unscrew the boiler
cap while it's still
steaming.

Storing the generator

• Turn off at the main switch and unplug.
• Wind the electric cord around the cord tidy (F).
• Place the iron on the rest.
• Slot the extension cord outlet in the notch (according to model). Take the end of
the cord support and press to return the flexible part into the base (E).
• Storing the steam cord (G).
• Leave the steam generator to cool down before putting it away if it is stored in a
cupboard or confined space.
• You can store your steam generator in complete safety.

Maintenance and cleaning

Before cleaning, ensure that your steam generator is unplugged and that the
soleplate and the iron rest have cooled down.
Do not use detergent or descaling products for cleaning the soleplate or the base unit.
Never hold the iron or the base unit under the tap.

Cleaning the soleplate

• Regularly clean the soleplate with a non-metallic sponge.
26/06/06 15:03
• VERY IMPORTANT : Before opening your boiler, ensure that there is no more
steam left inside by pressing the steam control button (C) located on the handle
of the iron and keep it pressed down until there is no more steam.
• Stop the generator by pressing the on/off switch and disconnecting the plug.
• Slowly unscrew the boiler cap.
• Using a water jug, fill with maximum 1 litre of water.
• Fill the boiler (A), taking care that the water does not spill over. If this occurs,
remove the excess water.
• Replace the boiler cap, screwing on tightly, reconnect your generator to the
mains, and switch it on.
• Wait until the boiler heats up. After approximately 8 minutes or when the
steam ready indicator light comes on (according to model), the steam is ready.
• Clean the plastic parts of the appliance occasionally with a soft dampened
cloth.
Page 25
Filling the boiler during use
Never place the iron on a
metal rest as this could
damage it.
Place it on the iron-rest
on the base unit : it has
non-slip pads and has
been designed to
withstand high
temperatures.

Cleaning the unit

GB
25