Technical Data; Installation - Electrolux IK335 User Manual

Problem
The temperature in the
refrigerator is too high.
Upper or lower square is
shown in the tempera-
ture display.
dEMoappears on the Dis-
play.
REPLACING THE LAMP
The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the light-
ing device. Contact your Service Center .
CLOSING THE DOOR
1. Clean the door gaskets.

TECHNICAL DATA

Dimension of the recess
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
POSITIONING
Install this appliance at a location where the
ambient temperature corresponds to the
Possible cause
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
An error has occurred in meas-
uring the temperature.
The appliance is in demonstra-
tion mode (dEMo).
Height
Width
Depth
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
2. If necessary, adjust the door. Refer to
"Installation".
3. If necessary, replace the defective door
gaskets. Contact the Service Center.
1780 mm
560 mm
550 mm
230-240 V
50 Hz
climate class indicated on the rating plate of
the appliance:
electrolux 43
Solution