Table of Contents
Advertisement
ENVIRONMENT OF OPERATION:
This appliance is designed only for home or indoor use but not for industry or commercial.
PRECAUTIONS:
X Please read this instruction manual carefully before installation, during the installation,
power supply must be disconnected.
l
. The installation should be carried out by a qualified technician.
. Do not put flame on the range hood. Please turn on hood before turning on the hob.
. Please clean your hood regularly to prolong the life of the hood.
. Cleaning procedure should follow the instruction stated in this manual.
. Air ventilation inside kitchen must be maintained in good condition when the hood is
used.
6. In case of lamp broken, please be sure that the power supply is disconnected before
change, just release the bottom damper to change the broken one, the maximum
power is 25W/220V bulb.
7. If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or other qualified persons in order to avoid a hazard.
8. Specifications may change without prior notice.
INSTALLATION:
X This appliance must be earthed. Installations must be carried out only when
power supply is disconnected.
1. Unpack the carton and take the unit out with discharged the polyform packing.
2. Detached the fan grille by unfasten the screw then take polyform out from inside and
reinstalled the grille.
3. The installation of height is measured vertically from the bottom of hood to the top of
stove, the best recommended height is 65-80cm. The left-right or up-down inclination
should be avoid.
4. This unit could be wall-mounted or built-in under the kitchen cabinet, drill 2 ®8 hole
on the wall and insert the inflation tuck properly
5. Unfasten the screw of the bracket and pull the bracket upward then fasten it, mount
the unit to the wall and balanced the inclination of unit then fasten the screws.
6. For cabinet built-in, use M5 screw to fasten on the bottom of the cabinet, the cabinet
should be afford 50kgs, the installation shown in Fig 1, the exhaust duct should go
out through the cabinet to window.
7. 6-inches diameter exhaust duct is recommended to use in order to maximize suction
efficiency. To increase the efficiency of hood, the length of exhaust duct should be
minimized and avoid acute turns.
8. Check the voltage on the rating label which should match the national or local code.
This appliance should be earthed.
9. During the installation, power supply must be disconnected.
ah
wn
=
4
Advertisement
Table of Contents
