Problem Solving - Smeg SDP20 Manual

12.PROBLEM SOLVING

PROBLEM
The Home Garden's lamps are
fully on during day time
The Home Garden's lamps are
off in the evening
The symbol is flashing
The symbol flashes even if
there is still a little water left in
the tank
When I press the
vapour is delivered
The tank has been
correctly, but the symbol is
still flashing
The symbol is flashing
When I fit the plug in the mains
socket a red point appears on
the left display
A blue point appears on the
right display
The steel side panels are hot
Problem Solving
PROBABLE CAUSE
- The external lighting level is
low and the sensor has set
the lamps
power-
- The lighting period set in the
pro-gram has ended
- No water in the tank
- The vaporiser is dirty
- There is always a minimum
amount of water left, which
cannot- be utilised-by the
vaporiser.
- The maximum number of
key, no
vapour jets allowed by the
circuitry has been exceeded
- The tank has been filled
beyond the maximum level.
filled
- You have not pressed the
key on the remote con-trol
- The external temperature is
higher than the preset maxi-
mum: the "Cuttings" function
is not required for growing
cuttings.
- The Home Garden is in
standby
- The remote control keys are
locked
- The cuttings function is acti-
vated
- The external temperature is
lower than the set tempera-
ture-: the Home Garden is
heating its internal micro-cli-
mate
- No malfunction
to maximum
- No malfunction If you wish to turn on the lamps
anyway, refer to paragraph "9.5 Internal light
key".
- Fill the tank as described in Section- "11.1 Filling
the tank"
- Clean the vaporiser, see paragraph "11.3 Clean-
ing the ultrasound vaporiser".
- Fill the tank as described in Section- "11.1 Filling
the tank";
- No malfunction
- Wait a few minutes and try again
- Empty the tank with a syringe or similar device
as described in paragraph "11.1 Filling the tank"
- Press the
- You can continue growing cuttings in any case
- Switch on the Home Garden as described in par-
agraph "9.2 Standby key"
- To unlock the remote control hold down the
key for a few seconds as described in paragraph
"9.2 Standby key"
- Do not touch the surface underneath the pots
with your bare hands.
- No malfunction
POSSIBLE SOLUTION
button on the remote control
45