To set the delay once the program has started, proceed as follows.
If the program you wish to carry out is the same as the one already
in progress:
•
press the START/PAUSE button (2) for a few seconds, until the
program lights 4 and 5 (marked "end") come on;
•
annul the program in progress (see relative section) and wait for the
cycle to come to an end;
•
select the program again;
•
select the delay required;
•
press the START/PAUSE button (2) to start the new program.
If the program you wish to carry out is different from the one
already in progress:
•
press the START/PAUSE button (2) for a few seconds, until the
program lights 4 and 5 (marked "end") come on;
•
change the program;
•
select the delay required;
•
press the START/PAUSE button (2) to start the new program. The
dishwahser will pump out the water and restart with the delay set
and the new program.
16
User instructions