Service Points - Hitachi C3S2A Service Manual

6. Service Points

Cautions when removing the PWB assembly Drive
When removing the PWB assembly Drive, there is danger of damaging the connector connecting cables and the
PWB assembly Signal.
1) Disconnect 7 cables and remove 3 screws.
Disconnect 7 cables
2) Lift up the rearward of the PWB assembly Drive to the front.
PWB assembly Drive
3) Disconnect 5 cables lifting the PWB assembly Drive.
Cautions when removing the POWER UNIT (BALLAST)
When removing the cable (CNBAR) connected to POWER UNIT (BALLAST) there is danger of damaging the small
PWB connecting cables.
POWER UNIT (BALLAST)
Remove 3 screws
Lift up
FRONT
REAR
Disconnect 5 cables
����������������������������������������
�����
���������������������������������������������
�������������������������
��
PWB assembly Drive
Disconnect the board-to-board connector.
17