Advertisement
YS-W130/W130P
SECTION
1
GENERAL
signal for synchronization) to this connector for camera
synchronization.
[3] SYNC OUT connector (BNC)
The synchronizing signal input to the SYNC IN
connector [2 ]is output unaltered from this connector.
Switch
setting
Cable type
RG-59B/U
100 m
200 m
300 m
(3C-2V)
(328 ft) max. | (656 ft) max. | (984 ft) max.
RG-6A/U
160 m
330 m
500 m
(5C-2V)
(524 ft) max. | (1082 ft) max.) (1640 ft) max.
RG-11A/U
200 m
400 m
600 m
(7C-2V)
656 ft) max. | (1312 ft) max./ (1968 ft) max.
[4] 75 switch
This switch controls the 75-ohm termination of the
SYNC IN connector.
e When using the SYNC IN connector only, set the
monitor. The video signal input to the CAMERA IN
connector [5 ]is output.
power on, it will not operate. Be sure to complete the
connections before switching the power on.
e If you switch the power off then want to switch it back on,
wait 3 or 4 seconds before turning the power switch on.
—5—
Advertisement
