Table of Contents
Advertisement
en Home Connect
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tip: Please also follow the instructions in the
Home Connect app.
Notes
¡ Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
→ "Safety", Page 2
¡ Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡ In networked standby mode, the appliance requires
a maximum of 2 W.
16.1 Setting up the Home Connect app
Install the Home Connect app on your mobile
1.
device.
Start the Home Connect app and set up access for
2.
Home Connect.
16.3 Home Connect settings
You can adjust the Home Connect settings and network settings in your appliance's basic settings.
Which settings the display shows will depend on whether Home Connect has been set up and whether the appliance
is connected to your home network.
Basic setting
Home Connect as-
sistant
Wi-Fi
Remote control status Monitoring
16.4 Operating the appliance with the
Home Connect app
You can use the Home Connect app to set and start
the appliance remotely.
24
Possible settings
Start the assistant
Disconnect
On
Off
Manual remote start
Permanent remote start
The Home Connect app guides you through the en-
tire login process.
16.2 Setting up Home Connect
Requirements
¡ The appliance is connected to the power supply and
is switched on.
¡ You have a mobile device with a current version of
the iOS or Android operating system, e.g. a smart-
phone.
¡ The Home Connect app has been installed on your
mobile device.
¡ The appliance is receiving signals from the WLAN
home network (Wi-Fi) at its installation location.
¡ The mobile device and the appliance are within
range of your home network's Wi-Fi signal.
Open the Home Connect app and scan the follow-
1.
ing QR code.
Follow the instructions in the Home Connect app.
2.
Explanation
You can connect your appliance to the Home Connect app via
the Home Connect assistant.
Note: If you are using the Home Connect assistant for the first
time, only the "Start assistant" setting is available.
You can use the Wi-Fi to switch off the network connection for
your appliance. When you have connected successfully once,
you can deactivate the Wi-Fi and not lose your detailed data.
As soon as you activate Wi-Fi again, the appliance connects
automatically.
Note: In networked standby mode, the appliance requires a
maximum of 2 W.
During monitoring, you can only view the operating status of
the appliance in the app.
If you convert from monitoring or permanent remote start to
manual remote start, you must activate the remote start each
time. You can open the appliance door within 15 minutes of
having activated remote start. Remote start will not be deactiv-
ated by this. Once 15 minutes have elapsed, opening the ap-
pliance door will deactivate manual remote start.
For permanent remote start, you can start and operate the ap-
pliance remotely at any time. If you often operate the appliance
remotely, it is helpful to set the remote start to "Permanent".
Advertisement
Table of Contents
