Supplier's Declaration Of Conformity - Danby DAC180EB3WDB Owner's Manual

Hide thumbs Also See for DAC180EB3WDB:

Owner's manual (66 pages)

Table Of Contents

Table of Contents

Available languages

OPERATING INSTRUCTIONS

REMOTE CONTROL REGULATIONS

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular

installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

1. Reorient or relocate the receiving antenna

2. Increase the separation between the equipment and receiver

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected

4. Consult the dealer or an experienced radio/TV technician for help

5. Changes or modifications not approved by the party responsible for FCC and Industry Canada

compliance could void the user's authority to operate the equipment.

This appliance complies with Part 15 of the FCC Rules and license-exempt RSS standards.Operation is

subject to the following conditions:

1. This device may not cause interference.

2. This device must accept any interference received, including interference that may cause undesired

operation.

This device complies with Canadian CAN ICES-003(B)/NMB-003(B)

This device contains:

FCC ID: 2ADQOMDNA21

IC: 12575A-MDNA21