Maintenance; Specifications - Sony PS-LX55 Operating Instructions Manual

Stereo turntable system
Table of Contents

Advertisement

MAINTENANCE
Stylus
Before playing a record, clean the stylus with a soft brush. Brush
the stylus from back to front. Never attempt to clean the stylus with
your finger tip. If a fluid stylus cleaner is used, make sure not to
moisten the stylus too much.
Cabinet
Clean the cabinet and dust cover periodically with a soft dry cloth.
If
the stains are difficult to remove, use a cloth moistened with a
mild detergent solution. Do not use solvents such as alcohol, ben¬
zine or thinner, since they will damage the finish.
Rubber mat
When the rubber mat becomes dirty, wipe it gently with a soft cloth
slightly dampened with water.
Lubrication
The turntable requires no periodic lubrication. The motor shaft is
lubricated at the factory for the life of the turntable.
SPECIFICATIONS
Turntable
Platter
Motor
Drive system
Control system
Speed
Wow and flutter
Signal-to-noise ratio
Automatic system
30 cm (12 in.), aluminum-alloy diecast
Linear torque BSL (brushless and slotless)
motor
Direct drive
FG servo control system
33'/j
rpm, 45 rpm
0.03% (WRMS)*, 0.035% (WRMS)
±0.045% (DIN)
75 dB (DIN-Bl
Lead-in, return, repeat, arm up/down, record
size selection
Tonearm
Type
Linear tracking tonearm
Pivct-to-stylus
length 75 mm (3 in.)
Tracking error
±0.1 °
Tracking force
adjustment range
±0.25
g
Usable cartridge
plug-in type, 6 g
Cartridge VL-45G (Supplied only with the PS-LX55C)
Type
Frequency response
Output voltage
Load impedance
Tracking force
Stylus
Weight
Moving magnet type
10 Hz to 20 kHz
3.5 mV at 1 kHz, 5 cm/sec., 45°
47 kilohms
1 to 1.5 g (1.25 g recommended)
Sony ND-145G
6g
* This new measuring method concerns only the turntable assembly, in¬
cluding the platter It excludes wow and flutter caused by the tonearm, the
cartridge, or the record. Measured by obtaining signal from magnetic pick-up
head.
General
Power requirements 120 V ac, 60 Hz
Power consumption
10 W
Dimensions
Approx. 355 x 85 x 355 mm (w/h/d)
(14 x
33/i
x 14 in.)
including projecting parts and controls
With the dust cover opended
Weight
Approx. 4 kg (8 lbs 13 oz), net
Approx. 4.7 kg (10 lbs 6 oz), in shipping
carton
Supplied accessory
45-rpm adaptor (1)
Design and specifications subject to change without notice.
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ps-lx55c

Table of Contents