Chapter 3
3. If the upgrade is interrupted, it's possible your extender may stop working and its LEDs blink once a second. In
this case, please connect your computer to the extender via an Ethernet cable, and set your computer to static IP
192.168.0.X and subnet mask 255.255.255.0. Then visit
3 11 6
Back Up and Restore Configuration Settings
The configuration settings are stored as a configuration file in the extender. You can
back up the configuration file to your computer for future use and restore the extender
to a previous settings from the backup file when needed. Moreover, if needed, you can
erase the current settings and reset the extender to the default factory settings.
1
Connect to the powerline extender wirelessly. Visit http://tplinkplc.net, and log in
with the password you set for the extender.
2
Go to
System
>
Backup &
To backup configuration settings:
Click
BACK UP
to save a copy of the current settings to your local computer. A '.bin' file
of the current settings will be stored to your computer.
To restore configuration settings:
1
Click
BROWSE
to locate the backup configuration file stored on your computer, and
click RESTORE.
2
Wait a few minutes for the restoring and rebooting.
Configuring via Web Management Interface
http://192.168.0.254
Restore.
to complete the upgrade.
30