Table of Contents
Advertisement
Pre-Installation Notes
Store the manual in a safe place in order to be able to use it as reference after installation. For maximum safety
installers should always carefully read the following warnings.
Store the provided manual in a safe location with the end user after installation, and remember to hand it over to
the new end user if the Heat Pump & Cylinder unit is sold or transferred.
The Air to Water Heat Pump is compliant with the requirements of the Low Voltage Directive (2006/95/ EC),
the EMC Directive (2004/108/EC) and the pressure equipment directive (97/23/EC).
The manufacturers shall not be responsible for damage originating from unauthorised changes or the improper
connection of electric and hydraulic lines.
Do not use units if you see some damages on the units and recognise something untoward such as loud noise,
smell or burning.
In order to prevent electric shocks, fires or injuries, always stop the unit, disable the protection switch and
contact Joule's technical support if the unit produces smoke, if the power cable is hot or damaged, or if the unit
is very noisy.
Always remember to inspect the unit, electric connections, refrigerant tubes and protections regularly. These
operations shall be performed by qualified personnel only.
The unit contains moving parts and electrical parts which should always be kept out of the reach of children.
Do not attempt to repair, move, alter or reinstall the unit by unauthorised personnel. These operations may cause
product damage, electric shock and fires.
Do not place containers with liquids or other objects on the unit.
All the materials used for the manufacture and packaging of the air to water heat pump are recyclable. The
packaging material and exhaust batteries of the remote controller (optional) must be disposed of in accordance
with local regulations.
The Air to Water Heat Pump containing a refrigerant must be disposed in an authorised centre or returned to
retailer as special wastes.
Wear protective gloves to unpack, move, install, and service the unit to avoid your hands being injured by the
edge of the parts. Do not touch the internal parts (water pipes, refrigerant pipes, heat exchangers, etc) while
running the units. If you need to adjust and touch the units, allow sufficient time for the unit to cool and be sure
to wear protective gloves.
In case of refrigerant leakage, try to avoid contact with the refrigerant because this could result in severe
wounds.
12
NO Pre Paid Meters are to be installed on a Samsung Air Source
Heat Pump System
Advertisement
Table of Contents
