Table of Contents
Advertisement
INSTALLATION OF ACCESSORIES
INSTALLING THE ANTENNA
Install the antenna as shown in the figure below and
turn it clockwise until it stops.
Note:
- When installing the antenna, don't rotate it by its top,
holding it by its base and turn.
- Ifyou use an external antenna, make sure the 'SWR' is
about 1.5:1 or less, to avoid damage to the transceiver's
final transistors.
= Do not hold the antenna with your hand or wrap the outside
of it to avoid bad operation of the transceiver.
~ Never transmit without an antenna.
INSTALLING THE BELT CLIP
If necessary, install the belt clip at the rear of the battery
compartment cover as shown in the figure below.
Note:
- Do not use any kind of glue to fix the screw on the belt clip
The solvents Glue may damage the battery casing
MICRO-HEADSET INSTALLATION OF EXTERNAL
Plug the external micro-headset connector into the jack of
'SP. & MIC'of the transceiver as shown in the figure below.
INSTALLATION OF ACCESSORIES
BATTERY INSTALLATION
-When attaching the battery, make sure the battery is in parallel and in good contact with the
aluminum chassis. The battery bottom is about 1 to 2 centimeters below the bottom of the
radio's body.
-Align the battery with the guide rails on the aluminum chassis and slide it upwards until a 'click'
is heard.
-The battery latch at the bottom locks the battery.
-Turn off the radio before removing the battery.
-Slide the battery latch, at the bottom of the radio's body, in the direction indicated by the arrow.
-Slide down the battery for about 1 to 2 centimeters,and then remove the battery from the radio's
body.
Advertisement
Table of Contents
