Advertisement
Operating and control elements
On/Off button
➀
Fan button
➁
Interior light on/off button
➂
Audible warning on/off button
➃
Child lock display
➄
Switching the appliance on and off
You are recommended to clean the appliance before switching it
on for the first time (see "Cleaning").
To switch the appliance on: Press the ON/OFF button
until the temperature display lights up.
To switch the appliance off: Keep the ON/OFF button
pressed for 3 sec. so that the temperature display goes out.
Setting the temperature
The temperature of both compartments can be set separately.
Select the appropriate compartment by press-
ing button
or
. The respective temperature
➇
➈
display flashes.
To reduce the temperature: Press the DOWN button.
To increase the temperature: Press the UP button.
The electronic controls will switch over automatically about 5 sec-
onds after the last time you pressed the button, and the actual
temperature will be displayed.
Audible warning signal
The audible warning signal helps to protect your wines against
excessive temperature fluctuations.
- It sounds when the door has been left open for longer than about
60 seconds.
- It sounds when the interior gets too warm or too cold. The
temperature display will also flash. The audible warning
device is switched off by pressing the ALARM button.
Fan button
Should you wish to use the wine cabinet to store wine for long periods
of time, activate the FAN button
on. Thereby a climate which corresponds to that of a wine cellar is
achieved inside the wine cabinet. Corks are prevented from drying
out due to an increased level of humidity.
8
Upper compartment temperature display
➅
Lower compartment temperature display
➆
Lower compartment activation button
➇
Upper compartment activation button
➈
Temperature setting buttons
➉
➀
. The light in the display comes
➁
Additional functions
In set-up mode you can set the child lock and adjust the brightness
of the display. The child lock is designed to protect the appliance
from being switched off accidentally.
Activating set-up mode:
• Press the FAN button
for approx. 5 seconds.
➁
- The display shows c for child lock.
Note: The value to be altered flashes.
• Select the required function by pressing the UP/DOWN button:
c = child lock, h = display brightness
• Now select/acknowledge the function by pressing the FAN button
briefly:
➁
> For c = child lock, press the UP/DOWN button
to select
c1 = child lock on or
c0 = child lock off and acknowledge with the FAN
button
. When the symbol
➁
is activated.
> For h = brightness, press the UP/DOWN button
to select
h1 = minimum to
h5 = maximum brightness and acknowledge with
the FAN button
.
➁
Exiting set-up mode:
Exit the set-up mode by pressing the ON/OFF button
after 2 min. the electronic system switches over automatically.
The normal operating mode is activated again.
is lit, the child lock
;
➀
Advertisement
