Table of Contents
Advertisement
SAFETY INSTRUCTIONS
READ
INSTRUCTIONS
—
Ail
the
safety
and
operating
instructions should be read before the
apptiance is operated.
RETAIN
INSTRUCTIONS
—
The operating instruc-
tions should be retained for future reference.
HEED
WARNING
—
All warnings
on the appliance
and in the operating instructions should be adhered
to.
FOLLOW
INSTRUCTIONS
—
All operating and use
instructions should be followed.
WATER
AND
MOISTURE
—
The appliance should
not be used near water — for example, near a
bathtub, washbowl, kitchen sink, laundry tub, ina
wet basement, or near a swimming pool, etc.
LOCATION
—
The appliance should be installed in a
stable location.
WALL
OR
CEILING
MOUNTING
—
The appliance
should not be mounted to a wall or ceiling.
VENTILATION
— The appliance shouid be situated so
that its location or position does not interfere with
its proper ventilation. For example, the appliance
should not be situated
on
a bed, sofa, rug, or
similar surface that may block the ventilation open-
ings; or, placed in a built-in installation, such as a
bookcase or cabinet that may impede the flow of
air through the ventilation openings.
HEAT
—
The appliance should be situated away from
heat sources
such
as
radiators,
heat
registers,
stoves,
or other appliances
(including amplifiers)
that produce heat.
POWER
SOURCES
— The appliance should be con-
nected to a power supply only of the type describ-
ed in the operating instructions or as marked on the
appliance.
POWER-CORD
PROTECTION
~— Power-supply cords
should be routed so that they are not likely to be.
walked
on or pinched
by items
placed upon
or
against them, paying particular attention to cords
at plugs, convenience receptacles,
and the point
where they exit from the appliance.
POLARIZATION
—
If your purchased product is pro-
vid ed with a polarized power plug, please read the
following
instructions.
This
product
is equipped
with a polarized alternating current line plug {a plug
having one blade wider than the other). This plug
will fitinto the power outlet only one way. This is a
safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the
SERVICE.ENTRANCE
1
EQUIPMENT
mf
POWER
LINES
—
An
outdoor
antenna
should
be
located away from power lines.
NONUSE
PERIODS
—
The power
cord of the ap-
pliance should be unplugged from the outlet when
left unused for a long period of time.
OBJECT
AND
LIQUID
ENTRY
—
Care should
be
taken so that objects do not fall and liquids are not
spilled into the enclosure through openings.
CAMSSE
REQUIRING
SERVICE
—
The appliance
should be serviced by Pioneer authorized service
center or qualified service personnel when:
e
The
power-supply
cord
or the
plug
has
been
damaged; or
*
Qbjects have fallen, or liquid has been spilled into
the appliance; or
The appliance has been exposed to rain; or
The appliance does not appear to operate normally
or exhibits a marked change in performance; or
e
The appliance has been dropped; or the enclosure
damaged.
SERVICING
— The user should not attempt to service
the
appliance
beyond
that
described
in
the
operating instructions. For all other servicing, con-
tact the nearest Pioneer authorized service center.
POWER
LINES
SERVICE
ENTRANCE
CONDUCTORS
r
GROUND
WIRE a,b
i
1
Q
t
c
GROUND
CLAMPS
aN
a
I
J
VY
ANTENNA
DISCHARGE
UNIT ¢
GROUND
WIRE 2,6
STAND
OFF
INSULATORS
b
ANTENNA
LEAO-IN WIRE
TO EXTERNAL
ANTENNA
"TERMINALS
OF PRODUCT
OUTDOOR
ANTENNA
GROUNDING
—
If an
outside antenna
is connected
to the antenna
terminal,
be
sure
the
antenna
system
is
grounded
so as to provide some
protection
against
voltage
surges
and
built
up
static
charges.
In the U.S.A. section 810 of the National Elec-
trical Code,
ANSI/NEPA
No, 70-1984,
pro-
vides
information
with
respect
to
proper
grounding of the mast and supporting struc-
ture, grounding of the lead-in wire to an anten-
na discharge unit, size of grounding conduc-
tors, location of antenna-discharge unit, con-
nection
to
grounding
electrodes,
and
re-
quirements for the grounding electrode. See
Fig. A.
a)
Use No. 10 AWG
(5.3 mm?)
copper,
No.
8 AWG
(8.4
mm?)
aluminum,
No.
17
AWG
(1.0 mm?)
copper-
clad steel, bronze wire, or
larger as ground wire.
b}
Secure antenna lead-in and
ground wires to house with
stand-off insulators spaced
from 4 feet (1.22 meters) to
6 feet (1.83 meters) apart.
c)
Mount
antenna
discharge
unit as closely as possible to
where lead- in enters house.
Use jumper wire not smatier
than No.6 AWG (13.3 mm?)
copper
or equivalent when
separate
antenna-ground-
ing electrode is used.
=
plurg should still fail to fit, contact your electrician
to replace your obsolete outlet. Do not defeat the
Seven ceaiace
safety purpose of the polarized plug.
pea
reg
lg
L—~%
CLEANIING
—
The appliance should be cleaned only
<i
with a polishing cloth or a soft dry cloth. Never
BONDING
clean with furniture wax, benzine, insecticides or
SUMEENS
other volatile liquids since they may corrode the
cabinet.
pe
CLAMPS
OPTIONAL ANTENNA
GROUNDING ELECTRODE
DRIVEN 8 FEET (2.44 ml
the — into THE EARTH IF
il
REQUIRED BY
$I
LOCAL CODES. SEE
FIG.A
u
NEC SECTION 810-21 (8).
IMIPORTANT 1
RISK OF ELECTRIC SHOCK
-DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT
REMOVE
COVER
{OR
BACK).
NO
USER-
SERVICEABLE
PARTS
INSIDE.
REFER
SERVIC-
ING TO QUALIFIED
SERVICE PERSONNEL.
The
l&%ghtning
flash
with
arrowhead,
within
an
equilateral triangle, is intended to alert the user of the
presenese of uninsulated ''dangerous voltage" within the
produc t's enclosure that may be of sufficient magnitude
to consstitute a risk of electric shock to persons.
IVIPORTANT 2
If the a:pparatus is fitted with AC mains power outlet(s),
see RE_LAR PANEL FACILITIES for convenient. connec-
tion.of additional Hi-Fi component(s}. Make all connec-
tions tc the AC outlet{s) and the signal terminals first.
Connecst the plug to the wall socket last, make sure that
the power switch is off. Disconnect the wall plug when
the eqegipment
is not in {regular}
use, e.g. when
on
vacationn,
FOR USE IN THE UNITED
KINGDOM
_ The wires in this mains lead are coloured in accordance
with the following code:
Biue:
Neutral
Brown:
Live
The wire which is coloured blue must be connected to
the terminal which is marked with the letter N or col-
oured black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or col-
oured red.
Advertisement
Table of Contents
