Operating A Cable Dok; Chassis (Kv-32S12/32S16) Woe. Csssssseessesreessessseseecreee Os - Sony TRINITRON KV-32S12 Service Manual

RR ALES a I IL LE I RTT I a PETAL EE EE.
Operating video equipment
Video operating
button:
vr ittons
Middle position
Use the video operating buttons on the remote
commander to operate the video equipment.
Operating a VCR Buttans on the remote
commander
To tur on or otf Press POWER
To change channels Press CH _+/-
Torewind thetape __'Press "8
Operating the laser-disc Buttons on the remote
player commander
To plav Press >
To stop Press
To pause Press 18
To resume normai playback,
press again.
To search the picture Keep pressing ®& or "4
forward and backward during plavback
To resume normal playback,
release the button,
Press CH +/-
To search the chapter
Note
¢ If the video equipment does not have a certain tunction, the
corresponding button on this remote commander will not
operate.
'Operating a cable
jeleyd
For cable. box control (Cable Mouse): users.
Set the CABLE BOX/TV selector to TV and
disregard the instruction below.
Follow these instructions to set the manufacturer's code
which will enable you to operate a connected cable box
with the pre-programmed remote commander. For
example, you can set the remote commander to operate
a connected Zenith cable box.
POWER (CABLE)
CODE SET
MODE
Low position JUMP
Q- 9 buttons
ENTER
CH +/~
CABLE BOX/TV
setector
1 Set the CABLE BOX/TV selector to CABLE
Box.
CABLE 6OX. TV
2 While pressing CODE SET, press 6 and 8
(Zenith's code number —see chart on the
next page) and ENTER.
"3° 8%
(continued)
Operations [ 25
3 use POWER(CABLE) and the TV control
buttons (0 - 9, ENTER, JUMP and CH +/-} to
operate the cable box.
POWER ®O@®®
@@O®
°38D
5 8
Od
To operate the TV
Set the CABLE BOX/TV selector to TV. Then use the
TV control buttons to control the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
iO
zs
Manufactures and code numbers (cable box}
Manufacturer Code number
JERROLD 60, 61, 62, 63, 64, 65, 73
PIONEER 69, 70
SCIENTIFIC ATLANTA 66, 67
TOCOM 71,72
ZENITH 68
Notes
» If more than one code number is listed, try entering them one
by one until you come to the correct code for your equipment.
{f you enter a new code number, the code number you
previously entered at that setting 1s erased.
* in some cases, your equipment may use a code that is not
provided with this remote commander and you may not be
able to operate your cable box with the supplied remote
commander. in this case, use the equipments own remote
control unit.
When you remove a battery from the remote commander, the
code may be erased. Reset the code each time you replace the
battery, if necessary.
°
26 | Operations