Channel Search - Philips DTR220 User Manual

Channel search

In the main menu you can choose between Automatic
Search and Manual Search.
After the initial installation, it may be required to search
for channels again, or to add specific channels that are
additionally broadcasted.
Note: In order to carry out a new initial installation, you have
to reset the device to its default settings, see page 15.
Automatic Search
This scan mode usually is the appropriate one, because
during this scan mode normally all channels are found
automatically.
1 Highlight Automatic Search and press the OK key.
2 Press the OK key to start the automatic scan mode
Following, the scan mode is started. After the search is
completed, the following is displayed:
3 By using the arrow key
- the channels found are to be added to the old list
(standard setting),
- the old channel list is to be overwritten,
- the new found channels are to be discarded.
4 Press the OK key.
Manual Search
This type of scan mode enables the specific search for an
individual channel. This in particular makes sense if you
only want to include one individual channel into your
channel list and you know the information on the channel
and frequency.
1 Highlight Manual Search and press the OK key.
U S T
16 SING THE ET OP
or , choose whether
B
OX
2 Successively select the adjustable values by using the
arrow key or .
- The desired Frequency is set by pressing the arrow
key or .
- The Frequency in MHz is entered via the numerical
keys of the remote control.
- The desired band width is set via the arrow keys.
3 Choose whether all channels or channels that are free-
to-air only are to be searched for.
4 Then highlight OK and press the OK key to start the
expert scan mode.
Following, the scan mode is started.
- If some channels were found, you receive the same
request as with regard to the automatic scan mode, see
previous paragraph.
- If no channels were found, a message is displayed. Press
the OK key.