Table of Contents
Advertisement
2. INSTALLATION
2.1. Installation
Make sure that installation is performed correctly, ad-
hering to all of the instructions in the specific installa-
tion guide provided with the appliance.
Warning
If any model has water connections, make
them before connecting the machine to the
electrical system.
> The
appliance
must
ground in compliance with local electrical code.
> Position the wine cellar with the aid of a second
person.
> Never use the open door to lever the wine cellar
into place.
> Avoid exerting too much pressure on the door
when open.
> The wine cellar must not be installed near heat
sources. If this is not possible, suitable insulation
must be used.
> The appliance must not be exposed to direct sunlight.
> Do not use the appliance outdoors.
> Installation and servicing should be carried out
by qualified personnel in compliance with current
standards.
> Ensure that an a licensed electrician performs the
electrical connection.
> If the power supply cable is damaged, to avoid any
danger, contact an authorized servicer immediately
and they will replace it, so as to prevent any risk.
> Always put on the necessary Personal Protective
Equipment (PPE) before performing any work on the
appliance (installation, maintenance, positioning or
handling).
> Before performing any operation involving the ap-
pliance, switch off the circuit breaker.
> If installed near another refrigerator, refer to the
installation guide.
> Do not try to repair the appliance yourself, contact
an authorized servicer.
> Do not install/use the appliance outdoors.
> WARNING: Make sure that the power supply cable
does not become caught or damaged when position-
ing the wine cellar.
> To prevent instability of wine cellar, install and se-
cure it correctly as indicated in the instructions pro-
vided in this manual.
> This device can be used up to a maximum height of
6000 feet/2000 meters above sea level.
be
connected
to
www.smeg.com
2.2. Connection to the electrical
power supply
The appliance is equipped with a Schuko type 16A
plug. It must be connected to the electrical mains by
means of a corresponding Schuko socket.
Important
Do not use extension cords and/or multiple
adapters for connection.
Warning
If energy is supplied through an alternative
energy power source (solar, geothermal,
etc..) or if home automation systems are in-
stalled, it is necessary to install the Alterna-
tive Energy Kit to integrate the unit into the
power grid.
2.3. Refrigerant
The refrigerant isobutane (R600a) is contained within
the refrigerant circuit of the appliance, a natural gas
with a high level of environmental compatibility, which
is nevertheless flammable.
> If the refrigerant circuit should become damaged,
make sure that no flames and sparks develop in the
room. Thoroughly ventilate the room in which the ap-
pliance is situated.
ISO 7010 W021
Warning
Fire hazard / Flammable materials.
Use special care during transportation, in-
stallation and/or cleaning so as to avoid dam-
aging the refrigeration circuit.
EN
9
Advertisement
Table of Contents
