Table of Contents
Advertisement
Note: Always remove or add an even number of chain links.
Note: Care must be taken to ensure that there is no twist in the hand chain loop.
Replacing the hand chain
Remove the hand wheel by unscrewing the pinion nut then unscrew the hand wheel from the pinion shaft, once the
hand wheel is removed, replace the hand chain with a new hand chain loop. Replace the hand wheel and screw
back onto the pinion shaft and then replace the pinion nut, screwing this back on to the pinion shaft.
If the trolley is fitted with removable hand chain retaining plates they are removed by unbolting the two bolts from
each plate and then the retaining plates can be removed. This will allow the hand chain to be easily removed from
the hand wheel. When the hand chain has been replaced the retaining plates can be reassembled.
5. Transport, Storage, Decommissioning and Disposal
Transporting the unit:
•
Do not drop or throw the unit, always deposit it carefully.
•
Use suitable transport means. These depend on the local conditions.
Storing or temporarily taking the unit out of service:
To ensure the continuing integrity of the unit you should store the unit in conditions that do not lead to damage or
deterioration. Therefore:
•
Inspect trolleys and accessories before placing into storage.
•
Never return damaged trolleys to storage.
•
The unit should be secured against unauthorised and unwarranted use.
•
Store the unit in a clean and dry place.
•
Protect the unit including all accessories against contamination, humidity and damage by means of a suitable cover.
•
Protect against corrosion.
•
Wipe off all dirt and water.
•
A light oil film should be applied to the adjusting
•
If the unit is to be used again after it has been taken out of service, it must first be inspected again by a competent
person.
Disposal
When the product comes to the end of its lifecycle, after taking the unit out of service, recycle or dispose of the parts of the
unit respecting local and national environmental regulations.
6. Manufacturer Testing and Verification
This product was manufactured under our single-unit control of quality and was passed with strict inspection in accordance
with our inspection standards.
Capacity (tonne)
WLL (kg)
1
1000
2
2000
3
3000
The operating temperature range is -30°C (-22°F) to +50°C (+122 °F) unless the unit has been specifically supplied
for the range -50°C (-58°F) to +50°C (+122 °F).
Unit 1, Greensfield Industrial Estate,
Willowburn Avenue,
ALNWICK, NE66 2DG
bar.
Test Load (kg)
Capacity (tonne)
1500
3000
4500
WLL (kg)
6
6000
10
10000
www.tigerlifting.com
Page 8 of 18
Manual Tiger APT-AGT En 201811 v2.2
Test Load (kg)
9000
15000
Advertisement
Table of Contents
