Dell S2425HS User Manual page 57

If the Brightness level adjusted is above the default level over 75%, the following
message appears:
• When you select Yes, the power message is displayed only once.
• When you select No, the power warning message is displayed again.
• The power warning message appears again only when you do a Factory Reset
from the OSD menu.
If you press any button other than the power button, the following messages appear
depending on the selected input:
If either HDMI 1 or HDMI 2 input is selected and the corresponding cable is not
connected, a floating dialog box as shown below appears.
See Troubleshooting
Adjusting to this value will increase power consumpiton above the default level.
Do you want to continue?
No HDMI 1 Signal form your device.
Press any key on the keyboard to wake up.
If there is no display, press the monitor joystick
to select input source.
The display will go into Standby mode in 4 minutes.
www.dell.com/S2425HS
www.dell.com/S2725HS
No HDMI 2 Cable
The display will go into Standby mode in 4 minutes.
www.dell.com/S2425HS
www.dell.com/S2725HS
for more information.
Yes
No
No HDMI 1 Cable
or
Operating the monitor | 57