Table of Contents
Advertisement
1. Lift the microwave, tilt it
forward, and hook the slots
at the back bottom edge
onto the four lower tabs of
the mounting plate.
2. R
otate the front
t
of
he oven up
t
against
he cabinet
bottom.
3. Insert a self-aligning screw through the top
center cabinet hole. Temporarily secure the oven
by turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.) Be sure to keep the power cord
tight. Be careful not to pinch the cord, especially
when mounting flush to the bottom of the cabinet.
Cabinet Front
Cabinet Front
Cabinet Bottom Shelf
Cabinet Bottom Shelf
Microwave Oven Top
Microwave Oven Top
4. Attach the microwave oven to the top cabinet.
5. Insert the 2 self-aligning screws through the
cabinet bottom and, if used, through the filler
blocks into the outer top of the unit. (See the
illustration above). Continue to support the unit
until both screws are inserted and engaged at least
two full turns, then fully tighten both screws until
the unit is secure.
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 17
DE68-04108A-08_IM_ME18H704SFB_AA_EN.indd 17
Filler Block
Filler Block
Equivalent to
Equivalent to
Depth of Cabinet
Depth of
Cabinet Recess
Recess
Self-Aligning Screw
Self-Aligning Screw
Step-by-step installation guide
6. Install the grease filters. See the Owner's Manual
packed with the microwave for instructions.
NOTE: For models with installed grease filters, you do
not need to install a filter
E. CONNECT THE DUCTWORK FOR OUTSIDE
TOP EXHAUST
1. Extend the house duct down to connect to the
exhaust adaptor.
2. Seal the exhaust duct joints using duct tape.
17
House Duct
2024-02-16 오전 9:30:38
2024-02-16 오전 9:30:38
Advertisement
Table of Contents
