Troubleshooting - ZyXEL Communications ZyWALL USG 100 Series Quick Start Manual

ZyWALL USG 100
Port Interface Zone
P1, P2 wan1,
wan2
P3, P4, P5 lan1
P6 ext-wlan
P7 dmz
AUX aux
CONSOLE n/a
Label Type
USB USB
P1~P7 RJ-45
AUX RS-232
CONSOLE RS-232
EXTENSION PCMCIA Insert a wireless LAN card to use the wireless LAN feature. At the time of writing, you
CARD SLOT

7 Troubleshooting

Problem Corrective Action
None of the LEDs Make sure that you have the power cord connected to the ZyWALL and plugged in to an
turn on. appropriate power source. Make sure you have the ZyWALL turned on. Check all cable
connections.
If the LEDs still do not turn on, you may have a hardware problem. In this case, you should
contact your local vendor.
IP Address and DHCP Settings
WAN DHCP clients
LAN1 192.168.1.1, DHCP server enabled Protected LAN.
WLAN 10.59.0.1, DHCP server enabled
DMZ 192.168.3.1, DHCP server enabled Public servers (such as web, e-mail and
None None
None None
Description
Connect a (USB) 3G wireless card to access the Internet through a 3G network. At
the time of writing, you can use the Huawei E220.
Use 8-wire Category 5e or above Ethernet cables to connect routers, switches,
computers, routers, access points, and so on.
Use an RS-232 console cable to connect dial backup/dial-in modem.
Use an RS-232 console cable to connect a local computer for command-based
management.
can use ZyXEL's G-170S wireless card. You can optionally insert a 3G wireless card to
access the Internet wirelessly via a 3G network. At the time of writing, you can use a
Sierra Wireless AC850 or AC860 3G wireless card.
ENGLISH
Suggested Use With Default Settings
Connections to the Internet
Wireless access points
FTP)
Auxiliary modem
Local management
7