Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for HotSpring HOT SPOT PACE
Summary of Contents for HotSpring HOT SPOT PACE
- Page 1 HOT SPOT COLLECTION ® QUICKSTART GUIDE...
- Page 2 This Quick Start Guide is intended to help you set up your hot tub quickly and easily. Use the camera on your smartphone to scan the QR code below or visit www.hotspring.com to find a digital copy of: ���� Test Your Fill Water •...
- Page 3 � Set the Water Temperature � Balance Your Water Use the control panel to set the temperature to your desired Dip a FreshWater® 5-Way Test 5-WAY TEST STRIP level, which should be at least 95°F (33°C). We recommend Strip or FROG @ease Test temperatures between 100°F (38°C) and 104°F (40°C).
-
Page 4: Using The Control Panel
Using the Control Panel Maintenance Tips Touch anywhere on the screen to turn on the control panel. Protect your investment for years to come with these MODE JETS Filter Cycle 1 & important tips. Filter Cycle 2 Sleep Temp Ready CARE FOR YOUR SPA SHELL AND COVER •... - Page 5 IMPORTANT SAFETY INSTRUCTIONS READ ALL OF THIS INFORMATION BEFORE USING YOUR SPA 63612 A (7-22)
-
Page 6: Safety Information
Safety Information • Do not connect any auxiliary components (for example, cable additional speakers, headphones, additional audio components) to the audio system unless approved by WATKINS WELLNESS . • Do not self service audio component by opening spa door as this may (READ AND FOLLOW ALL expose dangerous voltage or other risk of injury. - Page 7 • Persons taking medications which induce drowsiness, such as DANGER - RISK OF ELECTRICAL SHOCK tranquilizers, antihistamines, or anticoagulants should not use the spa. • Install at least 5 feet (1.5 m) from all metal surfaces. A spa may be installed within 5 feet (1.5 m) of a metal surface if each metal surface HEALTH PROBLEMS AFFECTED BY SPA USE is permanently connected by a minimum No.
-
Page 8: Important Spa Instructions
SPA SHELL AVOIDING THE RISK OF SKIN BURNS Your HOT SPRING spa has an acrylic shell. Stains and dirt generally will not adhere to your spa’s surface. A soft rag should easily remove • To reduce the risk of injury, before entering a spa the user should most dirt. -
Page 9: Electrical Information
ELECTRICAL INFORMATION Electrical Requirements The diagram below illustrates how to wire 230 volt permanently connected spa models: IMPORTANT: Fill the spa with water before turning on the power. • An electrical subpanel containing a GFCI breaker is included with each 230 volt spa. - Page 10 ELECTRICAL INFORMATION 230 VOLT CONVERSION 30 OR 50 Power Jumper Position (PACE, STRIDE, SX & TX MODELS ONLY) 230 VAC Wiring Conversion instructions (50A Converted) NOTE: An Authorized HOT SPRING Spa Technician must reconfigure 2 Position Power Jumper spa using the soft jumpers. must be removed on the Terminal Block to operate A licensed electrician must install the sub-panel (available from your...
-
Page 11: 115 Volt Operation
ELECTRICAL INFORMATION WIRING ILLUSTRATION PERMANENTLY CONNECTED FOR 115 VAC, 30A, 60HZ, CONVERTED MODELS 115VAC, 30 Amp Single Pole Circuit Breaker (Non GFCI) #10 AWG White, Neutral N, Neutral, #10AWG White #10 AWG Green, Ground #10 AWG Black, L1 L1, Hot, #10AWG Black Ground, #10AWG Green Main Service Electrical Panel... - Page 12 Watkins. Alteration includes, but is not limited to, and workmanship for two years. This warranty does not cover commercial or any component or plumbing change, or electrical conversion. Visit www.hotspring.com or industrial use spas or spas that have been improperly installed.