Advertisement
Available languages
Available languages
Hardware ( in plastic bag)
7/16 Locking Screw and Flat
Washer for window filler panels
1/2 Long hex head screw
Safety Lock
1/2 Long Screw
and locknut
3/4 Long Flat Head Bolt
and Locknut
foam insert
1
Remove Air Conditioner from Cabinet
NOTE: Remove any packaging material from cabinet exterior.
1. Pull down on front grille from upper edge. Lift front grille upwards and place to one side. (See FIG.1)
2. Remove filter. To remove, grasp in the middle on each side. Bow filter out to detach top edge from tabs. Once top
is free, lift filter up and out.
FIG.1
3. Locate the four Front Panel screws and remove. These screws will be needed to re-install the Front Panel later
(See FIG.2).
4. Push metal cabinet side inward to release plastic tabs on each side of Front Panel (see Fig. 3).
5. Rotate Front Panel up until top tabs are free. Pull panel straight out. When pulling out, front panel will also pull free
from vent control lever. Depress latch on electronics plug (on some models) to disconnect.
6. Remove Front Panel from unit (see Fig. 4).
FIG.3
Installation Instructions
Qty.
2 ea
4 ea
2 ea
Window
Front Grille
Hardware ( in plastic bag)
Sill Angle Bracket
Long hex-head locking screw for top
7
angle rail, side retainer 5/16 long
1
(for Vinyl-Clad window)
Locking screw #10 X 1/4 panhead
Phillips screws (for Vinyl-Clad window)
2
Mounting
FIG.4
Main control cord
Safety Lock
weather stripping
(10 X3/4 X1/12 )
FIG.2
base pan handle
Qty.
2
10
2
2
5
3
Advertisement
