Table of Contents
Advertisement
28 OPERATION
1
Press and hold Clock
press Clock repeatedly until
in the display.
2
Set the number of degrees to adjust :
• Press or press and hold plus (+) or minus (-)
until the desired number of degrees
c
appears in the display.
• The temperature adjustment is shown next
to
.
AdJU d
• You can adjust the temperature up or down
by 35 °F or 19 °C.
3
Press START
to accept the change.
e
NOTE
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be adjusted by ±35 °F (±19
°C).
• Once the temperature is adjusted, press
Settings repeatedly until
see the amount you adjusted and change it if
needed.
• The temperatures displayed by an oven
thermometer placed in the oven cavity may
differ from the actual set oven temperature in all
modes.
Turning the Preheat Alarm Light On/
Off
When the oven reaches its set-temperature, the
preheating alarm light flashes 5 times or until the
oven door is opened.
You can activate or deactivate the preheating
alarm light.
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until
the display.
2
Press plus (+) or minus (-) to turn the light on/
off.
3
Press START to accept the change.
for 3 seconds. Then
a
appears
AdJU b
is displayed to
AdJU
appears in
PrE
Adjusting the Beeper Volume
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until
the display.
2
Press plus (+) or minus (-) to select the
desired volume.
3
Press START to accept the change.
NOTE
• Adjusting the beeper volume does not affect the
preheat alarm volume.
Selecting Fahrenheit or Celsius
Set the oven temperature display to show either
Fahrenheit (℉) or Celsius (℃) units. The oven
defaults to Fahrenheit unless changed by the user.
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until
the display.
2
Press plus (+) or minus (-) to select F
(Fahrenheit) or C (Celsius).
3
Press START to accept the change.
Adjusting Cooktop on Alert Volume
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until
the display.
2
Press plus (+) or minus (-) to select Hi, Off.
3
Press START to accept the change.
Turning the Wi-Fi On/Off
You can turn the Wi-Fi transmitter on the PCB on
or off.
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until Wi-Fi appears in
the display.
appears in
8EEP
appears in
UNit
appears in
CtOP
Advertisement
Table of Contents
