Table of Contents
Advertisement
be listed in the Hidden tab. If the channel is already
hidden, it will be visible again in the guide when the
Select button pressed.
Connecting to the Internet
You can access the Internet via your TV, by connecting
it to a broadband system. It is necessary to configure
the network settings in order to enjoy a variety of
streaming content and internet applications. These set-
tings can be configured from Settings>Network menu.
Wired Connection
Connect your TV to your modem/router via an Ethernet
cable. There is a LAN port on the rear side of your TV.
Your TV will not automatically connect to the network.
You will need to enable it manually using the Enable
Wi-Fi/Ethernet option in the Network menu. Highlight
this option and press Select to enable.
You can check the status of the connection using the
Ethernet Configuration option in the Network menu.
Highlight this option and press Play/Pause button on
the remote to see the network status.
To configure your wired connection settings manually
highlight Ethernet Configuration and press the Select
button. Follow the on-screen dialogues to proceed and
enter the required values respectively.
If the Ethernet cable is not connected, depending on
the current connection status, Configure Ethernet
Connection or Configure Network option will be
available instead of Ethernet Configuration option.
1
2
3
1.
Broadband ISP connection
2.
LAN (Ethernet) cable
3.
LAN input on the rear side of the TV
You might be able to connect your TV to a network
wall socket depending on your network's configuration.
In that case, you can connect your TV directly to the
network using an Ethernet cable.
1
1.
Network wall socket
2.
LAN input on the rear side of the TV
Wireless Connection
A wireless LAN modem/router is required to connect
the TV to the Internet via wireless LAN.
Highlight Enable Wi-Fi/Ethernet option in the Network
menu and press Select to enable wireless connection.
Then disconnect the Ethernet cable, if connected
priorly. Some of the available networks will be listed.
Highlight See All Networks and press Select to see
the complete list.
If you prefer to connect your TV to your network via
WLAN you have 3 ways to do this.
• Highlight one of the listed available wireless networks
and press Select. Then enter the password if the
network is password protected.
• Use the WPS button on your router. Highlight Join
Network Using WPS (Button) option and press
Select. Press the WPS button on your router. Your
TV will connect to your router, without the use of a
password.
Note: During the initial setup process Connect using
WPS Push Button option will be available instead of Join
Network Using WPS (Button) option.
• Enter WPS PIN on your router. Highlight Join
Network Using WPS (PIN) option and press Select.
A code will be created and displayed on the screen.
Enter this code on your router. Your TV will connect
to your router, without the use of a password.
Note: During the initial setup process Connect using WPS
PIN option will be available instead of Join Network Using
WPS (PIN) option.
English - 24 -
2
(**) Limited Models Only
Advertisement
Table of Contents
