Table of Contents
Advertisement
VHS Index Search System
Each time you start a recording,
an invisible index mark is
automatically placed on the tape.
You can then use these index
marks to access or scan your
recordings.
REWIND
FAST FORWARD
Direct Access
This feature allows you to go directly to the recording you want
from anywhere on the tape by entering a specific index number.
Push INDEX in
Playback or Stop mode.
Push a NUMBERED keys to
select the desired recording.
♦ To calculate the number, see below.
Push REW or FF to
start the Index Search
forward or backward.
• When the designated location
is reached, the VCR goes into
Playback mode.
To calculate an Index Number
Make each entry within 10
seconds, or the Index Search
mode will be canceled.
Index marks will be placed
for Timer recordings as well.
• If the Direct Access index search is
initiated extremely close to an index
mark, there is a possibility that the index
mark will not be counted in the search.
Count forward or backward each recording start point including the
recording you want to see from wherever you are on the tape.
Example 1:
If you are watching recording 4 and you want to watch recording 2, count the
start points to number 2. Recordings equal 3. Enter 3 in step "2" and push REW.
Example 2:
It you are watching recording 2 and you want to watch recording 6, count the
start points to number 6. Recordings equal 4. Enter 4 in step "2" and push FF.
NOTE: I indicates start points of each recording.
Index Scan
This feature allows you to scan (forward or reverse) each recording
for 10 seconds in Playback mode.
Push INDEX In
Playback or Stop mode.
Push REW or FF
to begin the scan.
• As each index mark is
reached, a short playback will
be performed after which FF
or REW resumes.
Push PLAY to cancel the
scan and begin playback.
• You may also push STOP to
stop the tape.
Start here
Advertisement
Table of Contents
