Table of Contents
Advertisement
en-us Installation and connection
Water drain connection types
NOTICE:
In the event of a blocked or covered outlet, accumulated
wastewater can flow back into the appliance.
Before operating the appliance, ensure that the
▶
wastewater drains away quickly and eliminate any
blockages.
Drainage into a siphon.
Drainage into a washbasin. Push the water drain hose
Drainage into a gully.
4.6 Connecting the condensation container
During the drying cycle, condensation forms; you can use
the water outlet hose to drain away this condensation
directly into the waste water system. If this is not possible
at the appliance's installation location, connect the
condensation container.
Note: Operate this appliance using the water outlet hose
provided.
→ "Connecting the water outlet hose", Page 9
If you connect the water outlet hose, you do not have to
regularly empty the condensation container.
→ "Emptying the condensation container", Page 22
10
Secure the connection point
with a (1/2"-7/8"
(12-22 mm)) hose clamp.
Secure the water drain
hose with a hose guide at a
height of at least 31 1/2"
(80 cm) and no more than
39 3/8" (100 cm).
Note: You can use the Y-
distributor → Page 19 to
connect the water drain
hose of an additional
appliance, such as a
washing machine, to the
same siphon outlet.
fully through the elbow and
secure it using fixing
material.
Secure the elbow at a
height of no more than
39 3/8" (100 cm).
Push the water drain hose
fully through the elbow and
secure it using fixing
material.
Secure the elbow to the
gully.
NOTICE:
When operating the appliance without the condensation
hose or water drain hose being connected properly, liquid
may leak out of the connecting piece.
Before operating the appliance, connect the
▶
condensation hose or water drain hose properly to the
connecting piece.
Requirements
¡ The appliance and the accessory have been unpacked.
→ "Unpacking the appliance", Page 7
¡ The appliance is installed at the installation location.
→ "Requirements for the installation location", Page 8
Empty the condensation container.
1.
→ "Emptying the condensation container", Page 22
Remove the stopper from the recess in the top
2.
insert it in the underside
When the appliance is delivered, the stopper is included
as an accessory in the scope of delivery.
Insert the condensation container.
3.
→ "Inserting the condensation container", Page 23
and
.
Advertisement
Table of Contents
