Special Features In The Programme Sequence; Spinning; Omitting The Final Spin (Rinse Hold); Anti-Crease - Miele PWM 514 Operating And Installation Instructions

Special features in the programme sequence

Final spin speed
Rinse-spin
Omitting the final
spin (Rinse hold)

Anti-crease

50

Spinning

When a programme is selected, the maximum spin speed for this
wash programme is shown in the display.
You can reduce the final spin speed.
However, you cannot select a final spin speed higher than that shown
in the chart.
There is a spin cycle after the main wash and between the rinse
cycles. A reduction in the final spin speed will also reduce the interim
spin speed as appropriate.
Select the Rinse hold Extra and then the Drain programme. After the

last rinse, the water will be pumped away and the Anti-crease phase
will switch on.
At the end of the programme, the drum continues to turn at intervals
for up to 30 minutes to help prevent creasing. The washing machine
can be opened at any time.
There is no anti-crease phase at the end of some programmes.