Table of Contents
Advertisement
en-us Troubleshooting
Issue
E:6103 lights up
E:90-01 lights up al-
ternately.
E:92-40 lights up al-
ternately.
A different error
code appears in the
display window.
E:01-00 to E:90-10
Dishware is not dry. No rinse aid used or dosage set too low.
42
Cause and troubleshooting
Not an appliance error. High loop is missing and/
or debris flushed back into drain hose and
blocked it.
Be sure there is a high loop in the drain hose
▶
and that no debris has flushed back into the
hose.
Power voltage is too low.
There is no problem with the appliance.
Call an electrician.
1.
Have the power voltage and electrical installa-
2.
tion checked by an electrician.
Filters are soiled or blocked.
Clean the filters.
▶
→ "Cleaning filters", Page 38
There is a technical issue.
Press
1.
Pull out the power cord plug of the appliance or
2.
switch off the breaker.
Wait at least 2 minutes.
3.
Insert the power cord plug of the appliance in a
4.
power outlet or switch on the breaker.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press
‒
Turn off the water faucet.
‒
Pull out the power cord plug.
‒
Contact customer service → Page 53 and
‒
give the error code.
Add Rinse aid → Page 22 .
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 23
.
.
Advertisement
Table of Contents
