Removal Of Power Supply Unit; Removal Of The Rear Holder - Philips VR6491 Service Manual

1-7
ad - Lift up the upper CBA's slightly and remove the plug.
— Put the upper CBA's in the upright position.
Note: Use the extended cable 4822 321 60545 when the
VCR must be operated with the upper CBA's in the
service position. qorecys
PMO2
Fig. 16
4.8 Removal of the rear holder
Note: Put the VCR on a 5-10 cm high box when
measuring in the PIP module. The rear holder with
45 166,411 the CBA's will move in a downward direction
Fig. 14 (Fig. 17).
4.6 Removal of the power supply unit.
~ Remove the fixing screw (Fig. 15).
— Take out the power supply unit in an upward direction.
REAR VIEW
45 167 Atl
Fig. 17
— Undo the screws S-15 and S-16 (Fig. 18).
(3-4) - Pull the CBA's out of the holder.
(S-15)
N
(s-15)
CS 27 437