Advertisement
Troubleshooting
Symptom
No power, or none of the
system LEDs are lit.
An individual LED should
be lit and is not.
Refer to the appropriate document for additional troubleshooting information.
H
FrameSaver 9620 User's Guide (Document No. 9621-A2-GB20)
H
FrameSaver 9620 Technical Reference (Document No. 9621-A2-GH30)
H
FrameSaver SLV 9820 User's Guide (Document No. 9820-A2-GB20)
Contact your sales or service representative to order product documentation.
Paradyne documents are also available on the World Wide Web at:
http://www.paradyne.com
Select Service & Support
Removing a Power Cord
When disconnecting a power cord/supply from an installed access unit:
1. Disconnect the power cord plug from the power outlet first.
2. Then, depress the locking tab of the 4-prong plug from the rear of the access unit
to disconnect the power supply.
Possible Cause
Power cord is not securely
plugged into the wall power
outlet or the universal
power supply.
Universal power supply is
not securely connected to
the power cord, or to the
rear panel connector.
Wall receptacle has no
power.
Power supply is defective.
LED is burned out.
Technical Manuals
3
Solutions
Check that the power cord
is securely attached at both
ends.
Check that the universal
power supply is securely
attached at both ends.
1. Check the wall
receptacle power by
plugging in some
equipment that is known
to be working.
2. Check the circuit
breaker.
Contact your sales or
service representative.
Run the Lamp Test. If the
LED in question does not
flash with the other LEDs,
then contact your sales or
service representative.
Advertisement
