Web Interface - Paradyne ENE2044 Installation Instructions Manual

Web Interface

The network extender's integral Network Management System (NMS) lets you configure
and monitor the network extender using a standard web browser.
To manage a Provider unit using NMS, connect your PC to any Ethernet port of the
Provider unit.
By default, the Subscriber unit can be managed by NMS through an active E1 line from
the Provider side of the network. To enable inband management and configure an IP
address, you must use the Command Line Interface. (See
page 13.) After that is done, the Subscriber unit can be managed through its Ethernet
ports.
Web Interface System Requirements
Web Browser – Required for running NMS. Compatible web browsers include, but
are not limited to, Microsoft Internet Explorer (v4.0 or higher) and Netscape
Navigator (v4.0 or higher). NMS is optimized for use with Internet Explorer.
Use your browser's default settings when running NMS. JavaScript must be
enabled.
Screen Resolution – 1024 x 768 pixels is the minimum resolution required for all
NMS views to fit within the dimensions of most monitors and laptops. Lower screen
resolutions (such as 800 x 600 pixels) may cause NMS screens to exceed the width
or height of the screen. To verify screen resolution on a Windows system:
— Right click on your desktop
— Select Properties
— Click the Settings tab
— Adjust the Screen Resolution as needed
Configuring Your Windows PC to Communicate with NMS
To communicate with NMS, your PC's Ethernet interface must be on the same subnet as
the network extender. For example, to configure the IP address under Windows XP:
Procedure
1. In the Windows task bar, click on the Start button, and then click on Control Panel.
2. Double-click on the Network Connections icon.
3. In the LAN or High-Speed Internet window, right-click on the icon corresponding to
your network interface card (NIC) and select Properties. (Often this icon is labeled
Local Area Connection.) The Local Area Connection dialog box is displayed with a
list of currently installed network items.
4. Ensure that the check box to the left of the item labeled Internet Protocol (TCP/IP)
is checked, and click on Properties.
Command Line Interface
10
on