Table of Contents
Advertisement
RECORDING
RELAY RECORDING
{using both decks for continuous
recording)
4.
Insert blank tapes in both decks.
2. Set the DOLBY NR switch @.
3. Set the REVERSE MODE switch @.
{see page 9)
4,
Press
the
pause
{ 00 } button
of the
deck
where
recording is to start.
5.
Prass the recording { © } button of the deck where
recording is to start.
6.
Select the recording source at the stereo amplifier,
7.
Adjust the recording level
(see page 11).
8.
Press the RELAY/SKIP button @.
The indicator will light up.
9.
Press the playback (<J or >) button of the deck where
recording is to start.
To Momentarily Stop Recording
* Press the pause ( 00 ) button,
¢ To resume recording, press the ( 00 ) button again.
When Recording is Finished
Press the stop ( [_]) button,
® Continuous recording can be performed either from deck
{to deck Hl or from deck {I to deck |.
«
When the REVERSE MODE switch (2) is in the one-way
+
{ == } position, relay recording is performed on the side
shown by the tape transport indicator.
*® When the REVERSE MODE switch e is in the two-way
{CE>)
position, operation
automatically
stops
at the
reverse side tape end, and the other deck starts recor-
ding from the forward side.
®
Relay recording is canceled after is has operated once.
For longer recordings, replace the already recorded tape
with a blank one and press the RELAY/SKIP button (7)
[RELAY/SKIP] indicator on).
@
To
cancel
the
relay
recording
mode,
press
the
RELAY/SKIP button @ again (turning the [RELAY/SKIP|
indicator off).
e
if a cassette without erasure preventing tabs is loaded,
the unit will not enter the recording
mode when the
recording.{ © } button is pressed.
e. Always make sure that the TIMER switch @ is in the
OFF position.
49
2
<RRBIOiS>
PARALLEL RECORDING
trecording on both decks at the same time)
1.
insert blank tapes in both decks.
2. Set the DOLBY NR switch @.
3. Set the REVERSE MODE switch @.
Press the pause { 0
} button.
4
5.
Press the recording { © ) button.
6.
Select the recording source at the stereo amplifier.
7
Adjust the recording level
{see page 11}.
2
Press the stop (
} button.
.
Select the tape transport direction.
* Parallel recording is performed in the direction (forward
or reverse) shown
by the tape transport indicator. To
change the tape transport direction, press the playback
{<1 or >) button, then immediately press the stop ( [7] )
button.
¢ Tape direction can be independently set for deck | and
deck Il.
10.
Press the PARALLEL REC button.
To Momentarily Stop Recording
* Press the pause ({ 00 } button (it will affect both decks).
* To resume
recording, press the ( 00 ) button again.
When Recording is Finished
Press the stop {[[] } button (it will affect both decks).
* 'The same source is recorded in both decks.
¢
Use tapes of the same length. Otherwise, the parallel
recording mode will be cancelled when the shorter tape
end is reached, activating the auto stop function.
*
if acassette without erasure preventing tabs is loaded,
the unit will not enter the recording mode when pressing
the PARALLEL REC button @.
©
Always start two-way recording from the forward side.
Operation will stop automatically at the tape end of the
reverse side.
*
Recording level adjustment is common to both decks, so
use tapes of the same kind.
®
When the recording mute { © } button is pressed, both
decks will enter the recording mute mode.
Advertisement
Table of Contents
