Samsung LA26B450C4H Service Manual page 75

Multi Code Remocon
Multi Code Remocon is a special transmitter which is designed to control each TVs with one remote.
- This function is useful in the place a large number of TV are provided like hospital Set ID number will be displayed in
source osd or center. There might be different in location of Set ID number depending on product and model.
- Samsung IR Signal Format
- Initial ID code which is transmitted is fixed as 0.
- It is possible to support up to 10 different remote key transmission for multi code
- Initial ID code which each TV has is "0".
Principle
- ID code could be from 0 to 9 because ID code is 4 bit signal
- Press Blue Key for over 3 seconds and the digit key a user wants to set.
- Set ID OSD will be displayed in central position.
The following words will be displayed.
"Remote control code is set to x. If you want to change Remote control code.
Enter the digit you want to change." (x is the digit number)
This OSD will be kept displaying until exit key is input.
- For example, TV and Remote will be set ID code #3 if user presses #3.
The following words will be displayed.
"Remote control code is changed to x" (x is the digit number)
- Then TV can be controlled by only remote which has same ID code with TV's.
- To change ID code, execute again as above.
- To reset ID code, press Yellow key for over 3 seconds. ID code of both TV and Remote will be reset to "0".
"Remote control code is set to 0." will be displayed.
- case that TV's ID code is "0" or Remote's ID code is "0", TV can decode IR signal without
consideration of ID code. Namely, TV can be controlled by all remotes.
- TV's ID code will sustain the last value even after AC power off & on, but will be initialized after factory reset.
4. Troubleshooting
4-49