Model 3810Plus Installation
DTE Connection
Use the following procedure to connect the RS-232D cable from the modem to the
DTE:
1. Make sure the modem's rear panel power switch is Off.
2. Connect the DB-25-P (male) connector on the cable to the DB-25-S (female)
connector labeled DTE 1 on the modem's rear panel. Use a small screwdriver to
fasten the cable to the modem.
3. Connect the DB-25-P connector on the cable to the DB-25-S connector on the
DTE. Use a small screwdriver to fasten the cable to the DTE.
LEASED-LINE
NETWORK
8-POSITION
PLUG
DIAL NETWORK
6-POSITION PLUG
DIAL
LEASED
TERMINAL
EQUIPMENT
CONNECTOR
SUB-MINIATURE
4-POSITION
PLUG FOR
NETWORK
MANAGEMENT
SYSTEM
OPERATION
3810Plus Rear Panel
DTE 1
DATA
DB-25-P
HUBBING
DEVICE
2
PWR
ON
OFF
NMS
POWER
SUPPLY
98-14677-03