"Remove the lower case" on page 62
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Peel off the tape.
Figure 58. Peel off the tape
Step 3.
Peel off the mylar carefully.
Note: The mylar is not reusable. Replace it when replacing related FRUs.
Figure 59. Peel off the mylar
Step 4.
Detach the main and auxiliary antenna cable connectors. Remove one screw and then remove the
Wi-Fi card by pulling it away from the slot.
.
Chapter 4
Removing a FRU or CRU
67