3.1.2 Memory Copy Function
With the memory copy function, the settings of the currently selected memory
number are duplicated to another memory. Use this function to leave most of
the settings unchanged with partial changes and use the memory switching
function.
Duplicate the settings of memory number 0 to memory No. 2.
1) Enter "0" for the source memory number.
<Detection state>
2) Return to memory number selection and select "copy".
3) Enter "2" as the destination
4) The data of memory number 0 is duplicated into memory No. 2.
5) After copying, memory number 2 becomes the current memory number.
Ramco Innovations www.ramcoi.com
Major applications
Keep the holding measurement conditions common and change only the
upper and lower limit judgment values.
Change only the material of the object to be detected.
*To use the memory copy function, select "Panel" for the memory
switching method setting in advance.
Refer to section "4.8Memory Switching Method Setting" on page 93.
Reference
Setting example
<Memory number selection>
Use
memory number.
Set
or
to select "copy".
Phone 800-280-6933 nsales@ramcoi.com
Use
or
to select "2".
Press
to copy.
Press
to return.
47